HAGRY - All Honda & Acura

As of March 2025, you will receive one male and one female digital LVDS cable. There is no longer a need for two identical male cables (the same cables as shown in the video) because nothing is connected behind the top screen. All plug-and-play connections are now done only behind the radio, also known as the bottom screen, if the vehicle is equipped. Please refer to the manual below for more information.

Read All Text before clicking any links or videos

FOR HONDA ACCORD ONLY:

If your Honda Accord has a single screen you do not have a AUX in the back of the radio, that AUX is in the front you will connected via RCA to 3.5 mm cable, navTool plug and play harness has two RCA is labeled audio output.

Factory Microphone Connection

For ALL Acura HONDA with HFL CABLE(Cars Without Navigation ONLY!)

If your Honda or Acura vehicle is not equipped with navigation then you have received the cable labeled HFL or HFL2

Cable HFL2 connects to the back of the radio. (must says HFL2 on the cable not just HFL)

A large cable with a sticker HFL Connect to your vehicle Bluetooth module, do not connect HFL plug to the NavTool interface

1. Honda odyssey Bluetooth module is located inside the dashboard behind the radio on the right side once you pull the radio out look inside of the dashboard on the right side you'll see a module with the block facing down with the Bluetooth logo that's your Bluetooth module for plug labeled HFL
2. set original microphone to ON in setting - all settings should be done while the phone is turned off or not connected to the interface

🆕-- NEW NEW OSD menu https://vimeo.com/641958396

Using windows, MAC or Google Chrome OS computer go to

https://config.navtool.com/ (desktop or laptop only)

Video is the same for all Honda and Acura because they all have the same radios

Correction to video manual For NEW NavTool 6.0 - NBT

🆕-- NEW audio is also now pre-wired into the harness, no need for AUDIO RCA

🆕-- NEW NEW OSD menu https://vimeo.com/641958396

🆕-- NEW applies only to RLX, MDX and TLX because RLX, MDX and TLX are equipped with digital steering will control "other cars do not have that" -You can use steering wheel buttons for Siri, track up, track down phone hang up and phone answer

🆕-- NEW there is no need to connect anything behind the screen any longer, so you are no longer required to have two identical cables the two different cables are shipped so you can connect everything behind radio

there is no need to connect anything behind the TOP screen any longer, connections for BOTH DATA cable are done behind the radio ONLY

please follow steps below for digital cable connection
step 1 unplug small gray connector back of the radio
step 2 plug in factory male connector into NavTool supplied female connector
step 3 connect other end of the supplied connector into the middle brown connector on NavTool plug
step 4 connect remaining connector into the back of the radio
step 5 connect other end of the cable to brown outer jack on NavTool

installation video (please keep in mind you have received NEW NavTool 6.0 so 2 correction above should be taken into account) - CLICK HERE TO WATCH THE VIDEO

AUDIO: Pre-Wired AUX Audio

1. Set Radio To AUX
2. Disable Bluetooth audio streaming, not calling but just audio streaming, usually done from car radio, in bluetooth audio settings.
3. If you don't disable Bluetooth audio, phone will force audio to Bluetooth instead of AUX